WJIECO 894A0-71010 PM Sensor Diesel Exhaust Sensor Particulate Matter Sensor Fits For Toyota Hilux 2GD-FTV 2.4L Turbo Diesel (2015–2020) Diesel Car 894A071010 0281007881 0281007856
WJIECO 894A0-71010 PM sensor is a direct OEM replacement diesel particulate matter sensor for Toyota Hilux equipped with 2GD-FTV 2.4L turbo diesel engine (2015-2020). Cross-replaces OE number 0281007881. Plug-and-play installation requires no ECU programming or dealer coding. Effectively resolves DPF soot related fault codes including P24C6, restores normal DPF regeneration, improves fuel economy and helps your vehicle pass emissions inspection. Built with high-temperature resistant housing for off-road, highway and daily driving. Backed by a 12-month WJIECO warranty.
- Estimated Delivery : Up to 4 business days
- Free Shipping & Returns : On all orders over $200
894A0-71010 PM Sensor Overview
The 894A0-71010 PM sensor is an OEM-grade diesel particulate matter exhaust sensor engineered by WJIECO for Toyota Hilux pickup trucks fitted with the 2GD-FTV 2.4L turbo-diesel engine from 2015 to 2020. Also known as a soot sensor or DPF particulate detector, this vital exhaust aftertreatment component measures real-time soot concentration downstream of the diesel particulate filter. It transmits precise signal readings to the vehicle ECM to manage and trigger active DPF regeneration cycles automatically.
If your Toyota Hilux 2.4 turbo diesel triggers a persistent check engine light, reduced engine power, DPF dashboard warnings, failed regeneration cycles or DPF-related diagnostic trouble codes such as P24C6, your factory particulate sensor is likely suffering from signal drift, burnt heating element or physical damage. Replacing the defective original sensor with this direct-fit 894A0-71010 replacement part is a cost-effective solution to fully restore your diesel particulate filter system.
OEM-Grade Construction and Strict Factory Testing
Our replacement 894A0-71010 PM sensor features a high-temperature resistant ceramic detection probe and reinforced anti-vibration internal circuit board. It is engineered to withstand extreme exhaust heat, vibration and dust from off-road, towing and highway driving. The outer housing, wiring harness and electrical plug connector are fully dimension-matched to OEM factory specifications, preventing wire cracking, water ingress and intermittent signal failures.
Every finished sensor unit goes through high-temperature aging testing, signal calibration and waterproof sealing inspection before shipment. This quality check eliminates common flaws found in cheap generic sensors, such as unstable soot readings, delayed signal response and early premature failure.
Exact Vehicle Compatibility
This exhaust particulate matter sensor is made to perfectly fit Toyota Hilux with 2GD-FTV 2.4L turbo diesel engines (2015–2020). It directly cross-replaces OEM part number 0281007881. As a core control component of the DPF system, the soot sensor allows the ECM to calculate exhaust particulate load and activate regeneration at the proper time. A faulty detector will cause constant warning lights, severe DPF clogging and failure to complete official emissions testing.
Core Benefits of Upgrading to the 894A0-71010 PM Sensor
Replacing your malfunctioning factory soot detector with our pre-calibrated WJIECO 894A0-71010 PM sensor delivers noticeable performance improvements and cuts long-term maintenance expenses. Unlike low-cost aftermarket sensors that repeatedly trigger fault codes due to poor calibration, our unit provides steady, accurate particulate data for the vehicle ECM.
Reliable sensor measurements enable the engine computer to run DPF regeneration at optimal intervals, reduce soot accumulation inside the diesel particulate filter, and prevent expensive full DPF replacement caused by irreversible blockage. After installation, you will recover throttle responsiveness, stabilize fuel consumption and clear DPF-related trouble codes.
Plug-and-Play Installation, No Dealer Programming Required
A key advantage of this 894A0-71010 PM sensor is its true plug-and-play design built for Toyota Hilux 2GD-FTV 2.4L turbo diesel models. This replacement part requires no ECU reprogramming, manual calibration, wire cutting or complicated mechanical modifications.
Installation works well for both professional repair garages and DIY vehicle owners. Simply remove the damaged old sensor from the exhaust pipe, align mounting holes and secure the new sensor, reconnect the factory wiring plug, then clear stored fault codes using an OBD diagnostic scanner. After a short normal driving cycle, the Toyota DPF emission system will return to stable operation without recurring warning alerts.
Every WJIECO sensor passes complete functional testing before leaving our factory. If you need a durable, high-precision and affordable OEM replacement soot sensor for your Toyota Hilux 2.4 2GD-FTV diesel pickup, our 894A0-71010 PM sensor is the ideal choice to restore your exhaust emission system.
| Weight | 0.3 kg |
|---|---|
| Dimensions | 18 × 12 × 6 cm |
Product Specifications
| Weight | 0.3 kg |
|---|---|
| Dimensions | 18 × 12 × 6 cm |
Categories
Tags
2GD-FTV 2.4D particulate matter sensor, 894A0-71010, DPF soot sensor replacement, PM sensor Toyota Hilux, replaces 0281007881, Toyota DPF sensor, WJIECO diesel sensor
1 review for WJIECO 894A0-71010 PM Sensor Diesel Exhaust Sensor Particulate Matter Sensor Fits For Toyota Hilux 2GD-FTV 2.4L Turbo Diesel (2015–2020) Diesel Car 894A071010 0281007881 0281007856
0 out of 5 stars
Add a review
Shipping & Warranty
- Worldwide shipping available
- Processing time: 1–2 business days
- Warranty: 12 months
- Support: hellogreatchipled@yeah.net

-2-700x700.png)
-700x700.png)





-2-138x138.png)
-138x138.png)





-300x300.png)

-3-300x300.png)
-300x300.png)

-1-300x300.jpg)



-300x300.png)


-2-300x300.png)
WJIECO Diesel sensor –
WJIECO 894A0-71010 PM Sensor is a direct-fit DPF soot sensor for Toyota Hilux 2GD-FTV 2.4L turbo diesel. Plug-and-play, fixes DPF trouble codes.