FS71-5L239-AA PM sensor 0281006609 0281006610 Particulate Sensor WJIECO Compatible with Fits For Ford MONDEO Diesel Vehicles Diesel Exhaust Particulate Matter Sensor OEM Replace Part Number FS71-5L239-AA 1904034 0281006609 0281006610 PM Sensor Automobiles Sensors

FS71-5L239-AA PM Sensor Overview

https://www.amazon.com/dp/B0F4XKV1VT

https://wjieco-autoparts.com/product/hc34-5l239-da/

The FS71-5L239-AA PM sensor is an OEM-grade diesel particulate matter exhaust sensor engineered by WJIECO for Ford Mondeo Mk5 vehicles equipped with the 1.5 TDCi diesel engine. Also referred to as a soot sensor or DPF particulate detector, this critical exhaust aftertreatment component measures real-time soot concentration inside the exhaust piping and transmits accurate signal data to the vehicle ECU to regulate active DPF regeneration cycles.

If your Ford Mondeo V 1.5 TDCi displays a persistent check engine light, reduced engine power, DPF warning messages, repeated failed regeneration attempts or DPF related trouble codes, your factory particulate sensor has likely suffered signal drift, heating element burnout or physical damage. Replacing the faulty stock sensor with this direct-fit FS71-5L239-AA replacement part is the most cost-effective way to restore full functionality to your diesel particulate filter system.

OEM-Grade Construction and Strict Factory Testing

Our replacement FS71-5L239-AA PM sensor adopts a high-temperature resistant ceramic detection probe and reinforced anti-vibration internal circuit board designed to withstand extreme exhaust heat and continuous road vibration during daily highway cruising. The outer housing, wiring harness and electrical plug connector are fully dimension-matched to original OEM standards, effectively preventing wire cracking, water ingress and intermittent signal failure.

Every finished unit undergoes high-temperature aging testing, signal calibration and waterproof sealing inspection before shipment. This process eliminates common defects found in cheap generic sensors, such as unstable soot readings, delayed signal response and premature component failure.

Exact Vehicle Compatibility

This exhaust particulate matter sensor is manufactured to perfectly fit Ford Mondeo Mk5 (V) 1.5 TDCi diesel models. It directly cross-replaces OEM part numbers 1904034, 0281006609, 0281006610. As a core control component of the DPF system, the soot sensor directly determines the ECU’s judgment of exhaust particulate load and triggers regeneration at the correct interval. A malfunctioning detector will trigger constant dashboard warning lights, severe DPF clogging and failure to pass official emissions inspections.

Core Benefits of Upgrading to the FS71-5L239-AA PM Sensor

Replacing your faulty factory soot detector with our pre-calibrated WJIECO FS71-5L239-AA PM sensor delivers measurable driving performance upgrades and reduces maintenance costs. Unlike budget aftermarket sensors that trigger recurring trouble codes due to inaccurate factory calibration, our unit outputs consistent, precise particulate data for the vehicle ECU.

Accurate sensor readings allow the powertrain computer to initiate DPF regeneration at the optimal timing, reduce excessive soot buildup inside the diesel particulate filter and avoid costly full DPF replacement caused by irreversible blockage. After installation, you will notice restored throttle responsiveness, stabilized fuel mileage and elimination of DPF-related diagnostic fault codes.

Plug-and-Play Installation, No Dealer Programming Required

A major advantage of this FS71-5L239-AA PM sensor is its true plug-and-play design customized for Ford Mondeo 1.5 TDCi. This replacement part requires no ECU reprogramming, manual calibration, wire cutting or complex mechanical modifications.

The installation workflow is friendly for both professional repair shops and DIY car owners. Simply remove the damaged old sensor from the exhaust pipe, align the mounting holes to secure the new unit, reconnect the factory wiring plug, then clear historical fault codes using an OBD diagnostic scanner. After a short normal driving cycle, the vehicle’s DPF emission system will return to fully stable operation without repeated fault alerts.

Every WJIECO sensor passes complete functional verification before shipment. If you are searching for a durable, high-precision and budget-friendly OEM replacement soot sensor for your Ford Mondeo 1.5 TDCi, our FS71-5L239-AA PM sensor is the ideal choice to restore your vehicle’s emission system health.

Ford JK4A-5L239-CA 0281007610 0281007611 Particulate Sensor WJIECO Brands Compatible with Fits For Ford Diesel Vehicles Diesel Exhaust Particulate Matter Sensor OEM Replace Part Number JK4A-5L239-CA 2368525 0281007610 0281007611 PM Sensor Automobiles Sensors